Aruba AP-120 Series Manual de usuario descargar pdf (Pagina 7)

Aruba AP-120 Series Indoor Access Point | Installation Guide 7

Connecting Required Cables

Install cables in accordance with all applicable local and national regulations and practices.

Ethernet Ports

The RJ45 Ethernet ports (ENET0 and ENET1) support 100/1000Base-T auto-sensing MDI/MDX

connections. Use these ports to connect the AP to a twisted pair Ethernet LAN segment or directly to an

Aruba Mobility Controller. Use a 4- or 8-conductor, Category 5 UTP cable up to 100 m (325 feet) long.

The 100/1000 Mbps Ethernet ports are on the bottom of the AP. These ports have RJ-45 female

connectors with the pin-outs shown in Table 1.

Serial Console Port

The serial console port allows you to connect the AP to a serial terminal or a laptop for direct local

management. This port is an RJ-45 female connector with the pinouts described in Table 2. Connect this

port in one of the following ways:

z Connect it directly to a terminal or terminal server using an Ethernet cable.

z Use a modular adapter to convert the RJ-45 (female) connector on the AP to a DB-9 (male)

connector, and connect the adapter to a laptop using an RS-232 cable. See Figure 7 for connector

details of the adapter.

NOTE

Aruba 12x APs are intended only for installation in Environment A as defined in IEEE 802.3.af, Power

over Ethernet. All interconnected equipment must be contained within the same building, including

the interconnected equipment’s associated LAN connections.

Table 1 Connector for Ethernet Ports ENET0 and ENET1

Connector Pin

Signal

Name

GE Connection

Connection

PoE

1 BI_DA+ Bi-directional pair A+ RX+ POE negative

2 BI_DA– Bi-directional pair A– RX– POE negative

3 BI_DB+ Bi-directional pair B+ TX+ POE positive

4 BI_DC+ Bi-directional pair C+ Spare pair POE positive

5 BI_DC– Bi-directional pair C– Spare pair POE positive

6 BI_DB– Bi-directional pair B– TX– POE positive

7 BI_DD+ Bi-directional pair D+ Spare pair POE negative

8 BI_DB– Bi-directional pair D– Spare pair POE negative

Table 2 Connector for Serial Console Port

Connector Pin Signal Name Function

3TXD Transmit

4GND Ground

5GND Ground

6RXD Receive

Pins not listed are not connected.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Aruba AP-120 Series Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan Aruba AP-120 Series